![]() Once the entire perimeter is splined, you’ll need to trim the excess screen.Now go back over the entire perimeter and check that the spline is pushed down all the way.Here, and any time during the process, if you end up with a sag or wrinkle, you can always pull the spline out in that area, make everything tight, and re-install the spline. When splining the last side, try to smooth out any wrinkles as you go.Once the short sides are complete, repeat the process on the long sides. Now move your spring clamps from the opposite short side and spline that section.When you get to the opposite corner, use the utility knife to carefully trim the excess spline, cutting away from the screen, toward the outer edge of the screen panel. As you progress, try using a spring clamp just in front of your work to keep the screen taut as you install the spline. ![]() Work slowly towards the opposite corner, making sure that the screen is pulled tight and the spline is pushed down all the way into the spline groove. With your other hand, keep the spline aligned in front of the tool.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |